Differences

This shows you the differences between two versions of the page.

--- etc:users:jcmvbkbc:hardware [2014/10/13 05:53] – created jcmvbkbc
+++ etc:users:jcmvbkbc:hardware [2016/08/08 20:53] (current) – ↷ Page moved from users:jcmvbkbc:hardware to etc:users:jcmvbkbc:hardware kel
@@ Line 2: / Line 2: @@
 ==== ARM-USB-TINY-H ====
-=== Low voltage UART mode ===
+Chip datasheet: http://www.ftdichip.com/Support/Documents/DataSheets/ICs/DS_FT2232H.pdf
-== Connector pinout ==
+=== Connector pinout ===
 <file>
 5 1
@@ Line 13: / Line 13: @@
 </file>
-, 2: Vcc (connected)
+=== Low voltage UART mode ===
-, 6 and the rest of the low row: GND (connected)
+== Pin functions ==
-: RX
+  * 1, 2: Vcc (connected)
-: TX
+  * 4, 6 and the rest of the low row: GND (connected)
+  * 5: RX (I)
+  * 7: CTS# (I)
+  * 9: TX (O)
+  * 11: RI# (I)
+  * 13: RTS# (O)
+  * 17: DTR# (O): my modification
 == Driver ==
-modprobe ftdi_sio vendor=0x15ba product=0x002a
+  * http://ftdi-usb-sio.sourceforge.net/
+  * modprobe ftdi_sio vendor=0x15ba product=0x002a
+  * echo -n "15ba 002a" > /sys/bus/usb-serial/drivers/ftdi_sio/new_id
+=== Xtensa JTAG ===
+== Pin functions ==
+  * 1: Vcc
+  * 3: TRST#
+  * 4: GND
+  * 5: TDI
+  * 7: TMS
+  * 9: TCK
+  * 13: TDO
+  * 15: SRST# (doesn't work)
+== topology.xml controller line ==
+  <controller id='Controller0' module='ft2232' probe='flyswatter' vid='0x15ba' pid='0x002a' usbser='OLVGHYS?' speed='10MHz'/>